Illuminated On•Off Key; Programming The Remote; Programming Methods; Brand Code Search And Entry - RCA RCR311B Manual De Instrucciones

Illuminated ON•OFF Key
ON•OFF
ON•OFF
(BLINK)

Programming the Remote

Your universal remote can operate a variety of brands of
components. In order for your universal remote to control your
components, you need to program the remote with the codes
that match the components (see Code Lists enclosed). These
codes enable the remote to communicate with your components.
Each brand and each component has its own "language," and,
by programming the correct codes into your remote, you tell the
remote to "speak the same language"as your components.
There are four methods you can use to program your remote
control to operate your components: Brand Code Search and
Entry, Direct Code Entry, Manual Code Search and Entry,
and Auto Code Search and Entry. Most components can be
programmed in one of these four ways. Try them in the
order listed.
The three-component universal remote is already
TIP:
programmed to operate most RCA, GE and PROSCAN branded
TVs, DVD players and satellite receivers.
In order to control combo TV/VCR or TV/DVD units, you must
program both the TV key and the VCR•DVD key. Once
programmed successfully, the TV key controls the TV functions
on your unit, and the VCR•DVD key controls the VCR or DVD
functions. There is a specific section in the Code Lists for combo
units. The codes in this section should be tried first, using Direct
Code Entry on the TV and VCR•DVD keys. If this is
unsuccessful, follow the normal programming methods for both
the TV and the VCR•DVD keys.

Programming Methods

Brand Code Search and Entry

If your brand is listed in the Brand Code List (See Code Lists
enclosed), you may be able to program your universal remote
by searching through only the Code Lists for that specific
manufacturer. Brand Code Search and Entry can be the quickest
method to program your remote, if your component (TV, VCR
and/or DVD, satellite receiver and/or cable box) is one of those
brands listed.
If your brand is not listed in the Brand Code List, use one of the
other programming methods: Direct Code Entry, Manual Code
Search and Entry or Auto Code Search and Entry.
Follow these instructions to program your remote using
the Brand Code Search and Entry method.
GO BACK
1. Manually turn on the component you want the remote to
control (TV, VCR, DVD, satellite receiver or cable box).
2. Locate the Brand Codes in the Code Lists and keep it handy.
Note: If you press an invalid key during the Brand Code
Search, the remote does not respond and the illuminated
ON•OFF key does not blink. If you do not press a valid
4
The ON•OFF key powers components on and
off. It also lights up to serve as an indicator
light, providing feedback for various functions.
When a valid key is pressed, the illuminated
ON•OFF key remains lit as long as the key is
pressed and turns off when the key is released.
The ON•OFF key also blinks in Programming
Mode or in Menu Mode to provide feedback.
For example, when programming your remote
via one of the programming methods, the
illuminated ON•OFF key blinks each time
a valid key is pressed.
TIP:
point in the Brand Code Search, press
and release the GO BACK key.
To exit without saving at any