Introduction; Battery Installation And Information; Battery Saver; Backlighting - RCA RCR311B Manual De Instrucciones

Three-Component
Universal Remote
Congratulations on your purchase of this three-component
universal remote. This universal remote controls up to three
electronic components and makes juggling remote controls a
thing of the past. You can program your RCA brand universal
remote to operate most models of most brands of infrared,
remote-controlled components manufactured after 1990.
(See the enclosed Code Lists for a complete list of brands.)
The three-component universal remote is easy to use, easy to
program and gives you control at the touch of your fingertips.
TIP: The three-component universal remote is already
programmed to operate most RCA, GE and PROSCAN branded
TVs, DVD players and satellite receivers. Just press the
corresponding key—VCR•DVD for a DVD player; TV for
a television; SAT•CBL for a satellite receiver or a cable box.

Battery Installation and Information

Your universal remote requires two AA Alkaline batteries
(batteries may or may not be included, depending on model).
To install the batteries:

Battery Saver

Your universal remote control saves battery power by automatically
turning off if any key is pressed for more than 60 seconds. This
saves your batteries should your remote get stuck in a place
where the keys remain depressed, such as between sofa cushions.

Backlighting

BACKLIGHT
1. Remove the battery compartment cover.
2. Insert the batteries, matching
the batteries to the (+) and (-) marks
inside the battery compartment.
3. Press and push the battery cover back
into place.
Note: Reprogramming may be
required after batteries are replaced.
Backlight illumination (available on select
models only) enables you to see the remote
control keys better in the dark. Backlight
illumination is toggled on or off with
successive keypresses of the BACKLIGHT
key. When toggled on, the backlighting
remains on as long as keys are being pressed.
The backlighting turns off six seconds after
the last keypress. Once the backlight time
has expired, any keypress will reactivate
backlighting. If the backlight illumination
is on, and the BACKLIGHT key is pressed,
the backlight turns off.
3