Mounting And Removing Flat Panel Screen - PEERLESS Mounts Smartmount ST650 Instalación Y Montaje

Mounting and Removing Flat Panel Screen

WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the fl at panel screen.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing screen from
the bottom.
Tension Adjustment of Ratchet Handle:
3
tension in tilt brackets (BB & CC) by rotating
ratchet handle. NOTE: If obstruction prevents
ratchet handle from rotating, pull handle out while
turning will allow handle to reposition without
tightening. Release and turn handle to tighten or
loosen.
Mounting Screen: Ratchet handle must be in the
up or down position or interference will occur while
hooking tilt brackets to wall plate (AA). Slowly hook
tilt brackets (BB & CC) onto wall plate (AA) and
swing screen down as shown in fi g. 3.1. Tilt bracket
hooks must fully engage wall plate as shown in
detail 1. Using phillips screw driver or security allen
wrench (FF), turn safety/security screws on tilt
brackets (BB & CC) clockwise till screw tip securely
contacts wall plate as shown in cross section.
Screen Adjustment: Screen can be adjusted
horizontally by loosening safety/security screws
on tilt brackets (BB & CC) three full turns. Adjust
screen as shown in fi gure 3.2. Tighten safety/
security screws on tilt brackets till screw tip
securely contacts wall plate as shown in cross
section.
Removing Screen: To remove screen from mount,
loosen safety screws, swing screen away from
mount, and lift screen off of mount.
Adjusting the Tilt Angle of the Flat Panel
Screen
4
For preset tilt angles use
custom tilt angle use ratchet handle.
INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°,
locator hole to fi nd tilt position hole and tilt screen
to align holes. Tighten IncreLok™ tilt locking
screws on both tilt brackets to lock tilt as shown in
detail 2.
Ratchet Handle: Loosen ratchet handle (refer
to step 3 for tension adjustment of handle).
or pull from top or bottom of screen to adjust tilt
as shown in fi g. 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
Adjust
Increlok™ and for
10° or 15°. Use
Push
9 of 38
AA
DETAIL 1
AA
SAFETY/
SECURITY
SCREW
CROSS SECTION
IncreLok™
TILT
LOCKING
SCREW
TILT
POSITION
HOLES
DETAIL 2
ISSUED: 11-21-07 SHEET #: 202-9255-5 05-12-10
All other brand and product names are trademarks or registered trademarks of their respective owners.
BB
&
CC
RATCHET
HANDLE
BB
&
CC
fi g 3.2
LOCATOR
HOLE
RATCHET
HANDLE
fi g 4.1
© 2009, Peerless Industries, Inc. All rights reserved.
Peerless Industries, Inc.
Melrose Park, IL 60160
www.peerlessmounts.com
fi g 3.1
3215 W. North Ave.