Publicidad
Idiomas disponibles
Idiomas disponibles
Position "Joe".
Top Strap Hooks:
Place where directed
by the Fit Sheet Notes.
Lower Strap Hooks:
Place where directed
by the Fit Sheet Notes.
Never place straps near
vehicle's hot exhaust .
Tighten
straps
again.
The weight of the
bikes may cause
the straps to slack.
••
IMPORTANT: Read NOTICE on front cover and GUIDELINES on back cover.
Do not install top hooks
to plastic or glass.
Refer to the notes for
your vehicle to see if
you should use the
Glass Hatch Hook in place of
the top or bottom hooks.
Glass Hatch Hook
is purchased separately.
Side Strap Hooks:
Position remaining hooks at side
mounting points from the Fit Sheet
Notes.
TIGHTEN SIDE STRAPS.
Pull
the
straps tighter
with two
hands.
Use the extra
strap to stabilize
bike wheels.
Support Frame:
Position frame at
recommended location from
the Fit Sheet Notes.
TIGHTEN UPPER
STRAPS.
Pull the straps tighter
with two hands.
Bundle the extra
strap ends into the
black band.
CAUTION, BEFORE EACH USE
✔ Periodically tighten all straps. Tighten with each new load.
✔ Keep bicycle tires and straps away from vehicle's exhaust.
✔ Never drive off-road with bicycles loaded.
Adjust top straps by
pulling on the ends, or
loosen by pressing the
metal buckles.
The load arms should be
tilted up slightly.
LOAD FIRST BIKE.
Match the seat
tube to the
stabilizing cradle.
PULL THE RUBBER STRAPS
SECURELY OVER THE TUBES.
••
Publicidad
