Replacing The Bulb; Power Cord Care - Riccar Prima R50SS El Manual Del Propietario

MAINTENANCE
SAFETY FIRST
Unplug Vacuum before performing any maintenance on your vacuum.
Replacing the Vacuum Belt
01
Remove plate
04
Install new belt by placing the belt around the
brushroll "belt groove"
NOTE
The belt on the Tandem Air Power
Nozzle is located on the opposite side as
demonstrated above.

Replacing the Bulb

01
Remove plate
TIP
To reduce the risk of electrical shock or injury from moving parts, turn the
vacuum off and unplug it.

Power Cord Care

• When the vacuum is in use, hold the cord to keep from running over it.
• Avoid obstructions and do not pull the cord around sharp edges or corners.
• Always keep the cord away from heated surfaces and never close doors on it
as this may cause damage to the wiring.
• To unplug, always grasp the plug, not the cord.
10
02
Remove belt cover guard
and pull out brushroll
02
Pull out bulb (no twisting)
*R50FSN and R50TAP
03
Locate and discard
broken belt
*R50FSN only
03
Reinsert new bulb and
place top cover back on