IKEA SAMFALLD Manual Del Usuario página 13

EN
Induction surface cooking zones
Figure 12: Induction cooking zone control
To operate an induction cooking zone:
1. Place correctly sized cookware on the cooking
zone.
2. Activate the cooking zone.
• If the cooktop is not on, press the Main
Power key.
• Press the On/Off key for the desired cooking
zone. If you just turned the cooktop on, this
step can be skipped.
3. Set the cooking zone to the desired level (refer
to Table 1).
• Place your fi nger on the control and slide
until the desired setting is indicated.
• Press Power Boost to set the zone to Power
Boil.
• Press 1 to set the zone to its lowest setting.
4. When cooking is complete, turn the induction
cooking zone OFF by pressing its On/Off key or
the Main Power key before removing the cook-
ware. If all of the zones are off, the cooktop will
automatically power off in 20 seconds.
IMPORTANT
Do not leave empty cookware on an operating
cooking zone. Cookware will heat very quickly and
may be damaged or warped if left on the cooking
zone empty.
NOTE
The cooktop has a sensor to detect cookware in
the cooking zone. The cooking zone will not be-
come active without proper cookware in position.
See "Pan Sensing" on page 10.
SETTING SURFACE CONTROLS
Suggested induction cooking zone settings
Start most cooking operations on a higher setting
and then turn to a lower setting to fi nish cooking.
The suggested settings found in Table 1 below are
based on cooking with medium-weight stainless
steel pans with lids. Settings may vary when using
other types of pans.
Induction Recommendations
Temp
Range
Low
Medium
Low
Medium
Medkium
High
High
Power
Boil
Table 1: Suggested induction cooking zone
settings
NOTE:
• The Power Boil (P) setting is available after acti-
vating a cooking zone by pressing the P key. The
cooktop will remain in Power Boil for up to 10
minutes. After 10 minutes, the cooking zone will
automatically change to the High (9) setting.
• The size and type of the utensil used and the
amount and type of food being cooked will infl u-
ence the setting needed for best cooking results.
• The Hot Surface indicator (H) will show in the
setting indicator when heat is detected in a cook
zone that has been turned off. The indicator
will remain on until the heated surface area has
cooled suffi ciently.
Power Description
Level
1 Keep foods warm
2-4 Continue cooking,
poach, stew
5-6 Maintain a slow boil,
thicken sauces and
gravies, steaming,
cooking
7-8 Continue a rapid boil,
fry, or deep fry
9 Start most foods,
maintain water at a
boil, pan frying, sear-
ing
P Start heating pans
that contain large
amounts of food or to
bring pots of water to
boil
13