Important Instructions For Unpacking And Installation; Grounding Instructions - IKEA SAMFALLD Manual Del Usuario

IMPORTANT SAFETY INFORMATION
IMPORTANT INSTRUCTIONS FOR
UNPACKING AND INSTALLATION
IMPORTANT
Read and follow the below instructions
and precautions for unpacking, installing,
and servicing your appliance.
Remove all tape and packaging before us-
ing the appliance. Destroy the carton and
plastic bags after unpacking the appliance.
Never allow children to play with packaging
material. Do not remove the wiring label
and other literature attached to the appli-
ance. Do not remove model/serial number
plate.
Cold temperatures can damage the elec-
tronic control. When using this appliance
for the fi rst time, or when the appliance
has not been used for an extended period
of time, be sure the appliance has been in
temperatures above 32ºF (0ºC) for at least
3 hours before turning on the power to the
appliance.
Never modify or alter the construction of
the appliance by removing the leveling
legs, panels, wire covers, anti-tip brackets/
screws, or any other part of the appliance.
Be sure to have an appropriate foam-type
fi re extinguisher available, visible, and eas-
ily accessible located near the appliance.
4

GROUNDING INSTRUCTIONS

WARNING
Avoid fi re hazard or electrical shock. Fail-
ure to follow this warning may cause seri-
ous injury, fi re, or death.
Avoid fi re hazard or electrical shock. Do
not use an adapter plug, use an exten-
sion cord, or remove grounding prong
from the power cord. Failure to follow this
warning may cause serious injury, fi re, or
death.
Proper Installation—Be sure your appliance
is properly installed and grounded by a
qualifi ed technician. In the United States,
install in accordance with the National Fuel
Gas Code ANSI Z223.1/NPFA No. 54, latest
edition and National Electrical Code NFPA
No. 70 latest edition, and local electrical
code requirements. In Canada, install in ac-
cordance with CAN/CGA B149.1 and CAN/
CGA B149.2 and CSA Standard C22.1, Ca-
nadian Electrical code, Part 1-latest editions
and local electrical code requirements.
Install only per installation instructions
provided in the literature package for this
appliance.
For personal safety, this appliance must be
properly grounded. For maximum safety,
the power cord must be securely connected
to an electrical outlet or junction box that
is the correct voltage, is correctly polarized
and properly grounded, and protected by
a circuit breaker in accordance with local
codes.
It is the personal responsibility of the con-
sumer to have the appropriate outlet or
junction box with the correct, properly
grounded wall receptacle installed by a
qualifi ed electrician. It is the responsibility
and obligation of the consumer to contact a
qualifi ed installer to assure that the electri-
cal installation is adequate and is in confor-
mance with all local codes and ordinances.
See the installation instructions packaged
with this appliance for complete installation
and grounding instructions.
EN