Operation - Glacier bay FW6AC012CP Guía De Instalación Y Cuidado

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to flush the water lines. Do not lose the gasket in
the aerator.
□
Ensuring the handles are in the off position, turn
on the water supply and check for leaks. If you
discover any leaks, check your connections to
ensure they are installed properly.
□
Use a wrench (T) to remove the aerator (B) from
the faucet (J). Turn on the hot and cold handles to
allow the water to run for at least one minute. This
flushes away any debris that could cause damage
to internal parts.
□
Turn off the water and reinstall the aerator and
housing (if applicable).
2
Removing the quick connecting hose
CAUTION: Use caution when removing the quick
connecting hose connections in order to prevent cutting
your hands.
□
If it is necessary to remove the quick connector, push the quick connecting hose (I) up,
hold the housing together and pull down.
1
B
2
9
A
J
3
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for
K
further assistance.