To Adjust The Backplate Height; To Install The Transport Guard; To Adjust The Harness - Husqvarna 553RBX Instrucciones De Operación

5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
6. Put the locking pin (C) in the hole to lock the shaft.
L
M
A
7. Turn the trimmer head /plastic blades (H) in the
opposite direction from which the trimmer head/
plastic blades rotate.
H
8. To disassemble, follow the instructions in the
opposite sequence.

To install the transport guard

1. Install the blade in the transport guard (A).
2. Put the two fasteners (B) into the slots (C) to attach
the transport guard.
B
A
14
C
C
M
H
C

To adjust the backplate height

1. Loosen the 2 fasteners that hold the backplate.
H
A
2. Loosen the backplate from the frame on 1 side.
L
3. Adjust the backplate to the correct height. Make sure
that the pin aligns with 1 of the holes on the frame.

To adjust the harness

1. Put on the harness of the product.
2. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
1104 - 001 - 11.04.2019