To Clean The Cooling System; Fuel Filter; To Clean The Air Filter; Bevel Gear - Husqvarna 553RBX Instrucciones De Operación

5. Turn the screw counterclockwise until the cutting
attachment stops.
WARNING: If the cutting attachment
does not stop when you adjust the idle
speed, turn to your nearest servicing
dealer. Do not use the product until it is
correctly adjusted or repaired.
6. Make sure the engine run smoothly in all positions.

To clean the cooling system

CAUTION: A dirty or blocked cooling system
can make the product too hot, which can
cause damage to the product.
The cooling system includes:
• The cooling fins on the cylinder (A).
• The air intake (B).
B
• Make sure that the cooling system is not dirty or
blocked.
• Clean the cooling system with a brush weekly or
more frequently if it is necessary.

To clean the air filter

CAUTION: An air filter that is damaged must
always be replaced.
If you use an air filter for a long time, it cannot be fully
cleaned. Replace the air filter with a new one at regular
intervals.
22
1. Remove the air filter cover and remove the air filter.
2. Clean the air filter with compressed air.
3. Clean the inner surface of the filter cover. Use air or
a brush.
4. Make sure that the filter is dry.

Fuel filter

When the engine runs short of fuel, make sure that the
air hole in the fuel tank cap and the fuel filter (A) are
clean.
A
B

Bevel gear

The bevel gear is filled to ¾ with grease at the factory.
Before you use the product, make sure that the grease
level has not changed. Use Husqvarna special grease if
it is necessary to fill up. Do not replace the grease in the
bevel gear. Let servicing personnel do the repair of the
bevel gear.

To examine the spark plug

CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
1104 - 001 - 11.04.2019
A