Publicidad
SLIDING DOOR HARDWARE - BI-FOLD
TM
4
HANG DOORS
• Fold door panels together and engage top pivot guide of pivot door into track pivot. (1)
• Set bottom pivot assembly into pivot bearing in jamb bracket. (2)
• Slide carrier bolt into top mount plate slot. (3)
1
Pivot
Pivote
5
ADJUST AND FINISH
• Screw snugger onto track in location based on number of doors.
• Install finish trim or casing.
• Move top pivot bracket in our out to adjust side clearance.
Note: Fasten finish header trim to either header OR wall, but not both,
so header can be removed later without damage.
Horizontal Adjustment:
To adjust tilt, slide jamb
bracket pivot bearing
in or out and tighten
in place.
Guide
Guía
Vertical Adjustment 2:
Rotate adjusting bolt on bottom pivot.
Turn right to lower door and left to raise.
3
2
Snugger Location
2-Door: Between top guide and side jamb furthest from the pivot.
4-Door: Between the pairs of door panels.
1/2"
(1,3 cm)
Rear
Arrière
Rear
#310386_A (1213)
Assembly
Instructions
Vertical
Adjustment 1:
Use wrench to
rotate carrier
bolt. Turn right to
raise and left to
lower. Adjust so
weight is evenly
distributed
across the top
of the track for
smooth and
even folding
action.
Aligners (4-Door ONLY):
Mount aligners on the back side
of door panels. Use aligners as
template and drill 3/32" diamter
holes and secure with (#8 x 3/4")
screws. (P)
Publicidad
