Publicidad
1
PREPARE OPENING
2
MOUNT FRAME HARDWARE
• Center track in opening.
• Using track as template, mark
screw locations.
• Drill 3/32" pilot holes and secure
with (#8 x 1-1/4") screws. (F)
Note: If necessary, track may be
cut with a fine tooth saw.
3
MOUNT DOOR HARDWARE
• Place carriers on back of each
door at the distance shown.
• Using carriers as a template,
drill 3/32" holes and secure
with (#8 x 3/4") screws. (E)
• Drill 1-3/4" diameter hole
approximately 1/4" deep
on outside edge of each
door as shown to mount pulls.
SLIDING DOOR HARDWARE - BY PASS
Hmax = Door Height + 2-1/16" • Hmin = Door Height + 1-5/8"
2-Door Width = 2 x Door Width - 1"
36"
(91,4 cm)
2" (5,1 cm)
#310388_B (0416)
Instructions
3-1/2"
(8,9 cm)
Opening Height
Hauteur Ouverture
Altura Abertura
1/2"
(1,3 cm)
1-3/16"
(3 cm)
Left Edge
Bord gauche
Borde izquierdo
Assembly
1-1/4" - 1-9/16"
(3,2 cm - 4 cm)
Door Height
Hauteur Porte
Altura Puerta
3/8" - 1/2"
(1 cm - 1,3 cm)
Right Edge
Bord droit
Borde derecho
Publicidad
