Introduction; Machine Specifications; 230V Electrical Connection Instructions - Amano American Sanders FloorCrafter Manual Del Operador

EN
The FloorCrafter can be used on a variety of surfaces. It is an ideal tool for wood flooring maintenance and restoration work.
Part #
Model
Electrical Requirements
Sound Emission (Lpm)*
Vibration
Motor
Contact Wheel Rate
Abrasive Rate
Abrasive Size
Fan Flow Rate
Drum Settings
Overload Protection
Electric Cable
Operating Controls
Leveling Controls
Operating Wheels
Weight
Dimensions
CAUTION: This machine will operate only on AC frequency and on electrical voltage shown on the motor nameplate. Make
sure you have the correct frequency and voltage before connecting the power cord to an outlet. The machine has
a plug as shown below.
This machine must be connected to an electrically ground circuit in order to pro-
tect the operator from electric shock. This machine has an approved power cord
with three conductors as well as a plug with three terminals. Connect the plug into
a three holed receptacle. For maximum protection against electric shock, use a
circuit that is protected by a ground fault circuit interrupter.
DANGER: Electrocution could occur if the machine is exposed to water or rain. Keep the machine in a dry building.
DANGER: Electrocution could occur if machine is improperly connected to the electrical system. To prevent possible electric
shock, always use a 3 -wire electrical system connected to an electrical ground. For maximum protection against
electrical shock, use a circuit that is protected by a ground fault circuit interrupter. Consult your electrical
contractor.
DANGER: Electrocution could occur if the ground pin is tampered with in any way. Do not cut, remove, or break the ground
pin. Do not try to fit a three-terminal plug into a receptacle or connector body other than a three-plug receptacle
or connector body. If the outlet does not fit the plug, consult your electrical contractor.
DANGER: Electrocution could occur if the machine is used with a damaged plug or power cord. If the cords or plugs are worn
or damaged in any way, have them replaced by an authorized service person or electrician.
Extension Cords
Use only an approved three-pronged extension cord with two main conductors
and one earthing conductor. This machine is equipped
with a power cord. When greater range is needed follow the table
to determine cable gauge of additional footage. Refer to the
chart to the right for extension cord information.
If motor appears to labor or takes a considerably longer time to come up to speed, reduce sanding pressure.

Introduction

Machine Specifications

07239A
FloorCrafter 8
240V~, 50Hz / 11.8 A, 2.2kW
96.2 dB(A)
2.88 m/s rms
2
3 Hp, (2.2 kW) Induction
2042 rpm
3750 ft/min (624 m/min)
29½" x 7⅞" (75 cm x 20 cm)
195 CFM (5,5 CMM)
80 lbs., 70lbs., 60 lbs. (36 kg, 32 kg, 27 kg)
Magnetic Circuit Breaker
12,2 m, H05VVF3G4.0 C13- Plug
Adjustable Lever/Grip
Externally Adjustable
80 Durometer Clear Urethane
204 lbs. (92,5 kg)
35" x 13¾" x 38¾" (89 cm x 35 cm x 98 cm)

230V Electrical Connection Instructions

Meter/Wire Guage (Stranded Copper)
Source Voltage
230
7
0-30 m 30-75 m
4.0 sq mm 6.0 sq mm