Gladiator GAJG48KDYG Instrucciones De Ensamblaje página 5

3.
Install Leveling Legs (optional)
Leveling feet (4)
A. Leveling legs
Place the cabinet on its side. Screw a leveling leg (P4) into each
of the four rivet nuts located at the corners of the cabinet as
shown. Stand the cabinet upright. If you have not already done
so, fasten the two bolts at each front corner, of the cabinet frame.
Completely tighten all the cabinet bolts and nuts.
P4
P1
P4
P3
A
4.
Install Shelves
F3c
F3c 5/16" hex-head bolt (12)
F5 5/16" flange nut (12)
P1
A
A. Middle pair of holes in cabinet side
IMPORTANT: Use the pair of holes located in the middle of the
cabinet sides to install a center shelf without the magnet (P5), so
the doors will lock. The other two shelves with magnet (P5m) may
be installed where desired.
Place a shelf (P5) so that the holes in the ends are aligned with
the pair of holes in the middle of the cabinet sides.
NOTE: Make sure the holes in the long edge of the shelf are
facing out.
Using two screws and nuts per side, fasten the shelf (P5) to the
sides (P1). Determine where you want to place the other two
shelves (P5m). Align the holes in the shelf ends with the holes in
the cabinet side.
NOTE: Make sure the magnets on the long edge of the shelf are
facing the cabinet front.
Using two screws and nuts per side, fasten the shelves (P5m) to
the cabinet sides (P1). Completely tighten the nuts.
F5
P2
P8
P1
P8
P5
P8
P8
P3
5