Attach Back Panels; Important - Gladiator GAJG48KDYG Instrucciones De Ensamblaje

2A.

Attach Back Panels

F3c Phillips-head screw (40)
IMPORTANT: Attach the back panels (P8) starting at the top
of the cabinet and working down to the cabinet bottom. Each
consecutive back panel will overlap the panel above. Do not
completely tighten the screws until all back panels are in place.
The back panels, top and bottom, may have additional holes that
are not used.
Align the first back panel (P8) with the holes in the cabinet top.
Using Phillips-head screws (F3c), attach the panel (P8) to the
cabinet top and sides. Overlap the bottom of the first back panel
(P8) with the top of the second back panel (P8) as shown. Using
Phillips-head screws, fasten back panel (P8) to the cabinet sides.
Repeat step to attach the four remaining back panels to the
cabinet sides.
4
F3c
2B.
Attach Back Panels
F3c
F3c Phillips-head screw (40)
P1
P3
A. Cabinet bottom
Using two Phillips-head screws, attach each back panel to the
panel above.
NOTE: Using three Phillips-head screws, attach the last back
panel (P8) to the cabinet bottom (P3).
Completely tighten all back panel screws starting with the sides
and continuing with the top, middle and bottom. Using the hex
key (provided), completely tighten all 24 cabinet bolts and nuts.
P1
A