Complete Assembly - Gladiator GAJG48KDYG Instrucciones De Ensamblaje

5.
Install Doors
F3c Phillips-head screw (12)
P2
P5m
P1
P5
A
P5m
P3
A. Phillips-head screws
IMPORTANT: The door with the lock assembly (P7) should be
installed on the right-hand side of the cabinet. The door hinges
are designed with keyhole slots at the top and bottom so the door
will hang on the cabinet while you are fastening the screws.
Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet. Hang the right-hand side door (P7)
from the top and bottom screws, and hand tighten. Insert the
middle four screws through the door hinge into the cabinet and
hand tighten. Repeat above steps to attach the left-hand
door (P6). Align the doors and completely tighten the screws.
1. Make sure there is a bolt or screw in each hole of the cabinet frame.
NOTE: The back panels, top and bottom, may have additional holes that are not used.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the cabinet by adjusting the height of the leveling legs. Turn to the left to raise
or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.
6
F3c
P7

Complete Assembly