Teka HPL-830 Guía Rápida De Uso página 26

3172492-003 EPIFA.QXD 14/02/14 10:12 Página 26
To disable the function, press the + and – sen-
sors at the same time for several seconds
until you hear a beep.
PROGRAMMING AND OPERATING THE PYROLITIC FUNCTION
Follow the instructions below to complete a
pyrolytic cleaning cycle:
1. IMPORTANT: Remove all accessories
(trays, grills, tray side supports, tele-
scopic guide rails) from inside the oven.
2. Turn the cooking control dial to the
Pyrolysis position
which confirms this function has been cho-
sen.
3. You will then see a P (pyrolysis programme)
on the timer display together and the
symbol will flash.
4. Press the + or – sensors to select one of
the pyrolysis programmes (P1, P2 or P3).
P1: Minimum programme (lasts 1 hour).
P2: Standard programme (lasts 1.5 hours).
P3: Maximum programme (lasts 2 hours).
5. After a couple of seconds, you will hear 2
beeps confirming the pyrolysis programme
chosen.
6. After a short time, the pilot light
on and the oven door will be locked.
7. The oven will start to heat up and the
symbol will appear permanently. The
timer display will show the time remaining
until the end of the programme.
IMPORTANT: At this point, the oven is pro-
grammed and the pyrolitic cleaning cycle is
underway. During the cycle, none of the oven
timer functions may be chosen (except the
child lock). Do not try to open the oven door
as this may interrupt the cleaning process.
26
. You will hear a beep
will turn
Caution
In the event of a power failure, your electronic
clock settings will be erased and 12:00 will
flash on the clock display. Reset the clock and
programme again.
8. When the pyrolytic cleaning cycle has
finished, an alarm will sound and the
symbol will flash.
9. Press any of the timer keys to turn the
alarm off. The symbol
10. Turn the cooking control dial to the posi-
tion .
11. Although the oven's heating process has
ended, it is extremely hot and cannot be
used. The cooling motor will operate until
the oven cools down and the pilot light
will remain on.
IMPORTANT
The cooling process may last up to 2 hours
because of the high temperatures inside the
oven.
12. Once pilot light
soon be able to open the oven door.
IMPORTANT
To open the door (pilot light
dial must be in position
follow step 10, set the control dial to position
and wait a few minutes until the door
unlocks and the pilot light turns off.
will disappear.
has turned off, you will
on), the control
. If you did not