Putting Into Service 7; Controls Interface; Description Of Icons; Selecting Functions - Beretta Idrabagno Lx 11Serie Manual Del Instalador Y Usuario

4 PUTTING INTO SERVICE

4.1 Controls interface

A
B
ON - OFF/RESET key
A
MENU - CONFIRM key
B
C + key
ON - OFF/RESET key
Allows the appliance to switch on and off. It also allows it to be reset in
the event of a fault.
MENU
pressed for more than two seconds, to access the technical menu (in this
+ and - keys
They allow you to navigate the various functions that are available, to
change the value of a parameter and to change the temperature that has
been set for the domestic hot water.

4.2 Description of icons

Bottle feeder function
Function for choosing temperature unit of measurement
General alarm
Domestic hot water pick-up
Flame presence
Flame lockout
Enter the technical menu
Flue gases fault

4.3 Selecting functions

Using the "+" e "-" keys it is possible to scroll through the available func-
tions on the display. The icon regarding the selection made blinks togeth-
er with the central segments.
In the case of the wrench (
or "oF" is displayed depending on the function that is currently active or
inactive. To change the status of the function:
- press the "+" and "-" keys
-
functions.
b
Keeping either the "+" or "-" key pressed, the fast scrolling mode
is activated.
Button lock function
Allows the keyboard to be locked out. It is activated or deactivated
through a combination of the keys ("+" and "-" keys pressed together for
7
C
D
- key
D
Fig. 1
Feeder bottle function
Selecting this function makes it possible to set the maximum temperature
If the function is not active,"oF appears on the display". If the function
is active, the "bottle feeder" temperature that was previously set is dis-
played.
The maximum value that can be set is established in parameter 11 (see
key select the desired value.
B
B
Function for choosing temperature unit of measurement
There are two possible units of measurement: Degrees Celsius and Fahr-
enheit.
The display shows the current unit of measurement. To change the value
enter the function (
Wrench function
When the wrench function is selected, the central segments of the display
technical menu (see section "
Solar
The function is only active if the installation is set up to operate with a
solar system.
is displayed.
ENGLISH
Fig. 2
Fig. 3
Fig. 4
21