BUTTON FUNCTIONS
STATE
STANDING BY
ON-HOOK
BUTTON
Open
pedestrian
door
Auto power-on
Garage door
opener
(*) To enter and exit programming state, hold button pressed for longer than 5 seconds. The yellow LED
will blink slowly to indicate that programming mode is selected. Programming mode will shut down in all
cases after the 10 minute timeout.
INDICATOR LEDS
2. Green LED on.
Indicates that a call is being received
6. Two-colour LED.
PRIORITY
FUNCTIONS
Rapidly blinking red: mute on
1
Green blinking: automatic door opener on
2
Red on steady: main calling station door open
3
Slowly blinking red: secondary calling station door open
4
Slowly blinking yellow: programming state on
5
To save programming, remember to hold the button pressed for longer than 5 seconds to quit
programming mode. In any case, after 10 minutes the system exits the programming state and
saves the modifi ed parameters.
Refer to the system booklet for how to program intercom calls.
RESET
To restore default parameters of the device after entering programming mode, hold button
longer than 5 seconds, hold buttons and hold
two long beeps to confi rm the command and exit the programming state.
DS1750-003B
RINGING
ON-HOOK
(RECEIVING
CALL)
Open
pedestrian
door
Special
function
—
(default: 7)
Video
switching
Garage door
opener
DURING
STANDING BY
AUDIO
OFF-HOOK
OPERATION
Open
Open pedestrian
pedestrian
door
Programmable
Special
intercom call
function
3 (Default: not
(default: 7)
programmed)
Programmable
Special
intercom call
function
2 (Default: not
(default: 8)
programmed)
Programmable
Garage door
intercom call
opener
1 (Default:
switchboard call)
pressed for longer than 3 seconds. The system will emit
PROGRAMMING
(WITH VIDEO DOOR
PHONE STANDING BY
ON-HOOK)
Connect / disconnect the
automatic door opening
door
Adjust door phone and
fl oor call volume (volume
changes according to
the following sequence:
LOUD, LOW, MUTE)
Floor call ring tone (5
different ring tones)
Door phone call ring tone
(5 different ring tones)
STATE*
system
pressed for
7