Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS:
Item includes: Fig. 1
A-Base
B-Pump
C-Fountain Top
D-Door Frame
E-Adaptor
1. unpack the product. Be sure that all parts listed are included.
2. Familiarize yourself with the water pump (B). the speed is con-
trolled by the switch located at the front of the pump. the speed is
indicated by a plus (+) and minus (-) sign. to increase the speed,
move the switch slowly in the direction of the plus sign. at its high-
est speed level, the switch will not move any further. to decrease the
speed, move the switch toward the minus sign. Similarly, at its low-
est speed, the switch will not move any further.
NOTE:
it is recommended the pump be set as its highest speed
during assembly and later adjusted to a lower setting if desired. Be
sure to unplug the pump before adjusting the speed setting.
3. place the base on a flat surface, and lead the pump cord through
the cord slot on the bottom of the base (Fig 2). this will ensure that
the unit is balanced when placed on a flat surface.
4. insure the door frame fits into the notch at the platform of the foun-
tain top, and adjust the direction of the leaf (Fig.3).
5. insert the pump outlet into the water tube. Be sure that the fountain
top stands on the base securely.
6. Fill the base with clean water up to the level of the platform surface
(Fig 4).
7. plug the cord into 120V household outlet. the fountain is controlled
by the switch located on the power cord, if pump doesn't operate,
rotate in-line switch once to turn on and once more to turn off.
NOTE:
Ensure that the electrical cord loops below the electrical out-
let to form a "drip loop". this will prevent water from running down
the cord into the electrical outlet (Fig 5). For best results, keep the
pump completely submerged at all times.
4
Fig. 1
D. door Frame
(leaf included)
Clean Water
A. Base
B. pump
Fig. 2
Flat Surface
Base
Switch
C. Fountain top
E. adaptor
5
Publicidad
