Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
NOTE: The magnet is pre-attached on the canopy bottom
cover (FF) for you to remove and install easily.
□
Pull off the magnetic canopy bottom cover (FF) from the canopy (C).
□
Loosen the two canopy screws (II) located in the bottom of the
mounting bracket (A), and turn the canopy counterclockwise to
remove the mounting bracket (A) from the canopy (C).
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(GG) must be completely tightened.
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
□
Loosen, but do not remove, the setscrew (GG) on the collar (KK)
on top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in the
collar (KK) and ball/downrod assembly (B). Be careful not to jam
the hanger pin (CC) against the wiring inside the ball/ downrod
assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (GG) on the collar on top of the fan-
motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan motor assembly
(E) through the decorative motor collar cover (D) and then
the center of the magnetic canopy bottom cover (FF).
□
Make sure the opening of the canopy (C) is on top and
insert the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly
(E) through the downrod as shown.
A
II
C
FF
CC
7
Please contact 1-855-HD-HAMPTON for further assistance.
C
FF
D
B
E
C
FF
D
B
DD
GG
KK
E
HAMPTONBAY.COM