PLANETARY MIXER
INSTALLATION
-
make sure that the device is disconnected from the mains, and the selector switch (2)
is set to "0"
-
make sure that the blender seat (5) is covered.
-
press the lock button (3) and swing out the base arm (4) until it locks
-
place the bowl (7) on the base (1) in its intended place and lock the bowl by turning it
right
-
fix one of the attachments (8,9,10) into the head (6). by inserting the attachment in the
head and locking it by turning it left fot. 2
-
press the button (3) and lower the base arm (4)
-
place the cover (11) by sliding it onto the bowl (5) fot. 3
HOW TO USE
-
before starting the device, make sure that all the components are properly installed
-
connect the device to the mains
-
to start the food processor use the selector switch (2). To choose one of 8 different
speeds of operation change the position of the selector switch (2).
-
the device is equipped with the "slow start" function – it reaches the desired speed after
a few seconds.
-
to activate pulsed operation turn the selector switch (2) in position "P". Releasing the
selector switch automatically returns it to position "0".
-
the ingredients may be added both before mounting the bowl on the base, and during
the operation of the device via the opening in the cover (11)
NOTE:
Choose the speed adequate for the type of the attachment fot. 1
The speed should be also adjusted to the consistency of the processed ingredients.
After use carry out the following:
-
set the selector switch (2) in position "0" and wait until the attachment stops moving
-
remove the cover (11)
-
swing out the base arm (4) by pressing the lock button (3)
Exercise caution when opening the base arm (4). It is recommended to hold it from
top so as not to open it too rapidly
-
remove the attachment by turning it right
-
unlock the bowl (7) by turning it left and remove it from the base (1)
NOTE
The device will not start if the base arm (4) is not lowered and locked.
The device will also not start if the selector switch (4) is not set to "0" when the arm
(4) is being lowered. To start the device in this case, after releasing the arm, turn the
selector switch (2) to "0", and then select the speed.
If the base arm (4) is raised during the operation, the device will stop. To resume the
operation of the device, lower the arm (4), turn the selector switch (2) to "0", and then
select the speed.
19