Technical Specifications - Sytech Easy Talk Serie Manual De Instrucciones

TROUBLE SHOOTING
? No voice
+ Check if the handset is well connected to the base unit. Check the telephone line.
? Battery rust or leak
+ Clean the inner battery compartment. Replace the batteries.
? Noise
+ Check if the circuit is damaged (Contact the Sytech Service center)
+ Check if the connector is moist or rust (Change the connector)
? No Tone
+ Check the line cord is correctly connected to the wall jack.
+ Check that the cradle on the handset is not blocked.
? Ring once then disconnect when receive a call. Dialing function is available
+ Check if connector is in a moist environment.
Check if there are too many extensions used together or the quality of the extension lines are not good
enough (Change the bad extensions)
? LCD becomes dim
+ Check if the LCD contrast is properly set and that the batteries are new (Adjust the LCD contrast; if the LCD
is still dim, replace the batteries.)
? Most of the functions failed
+ Check if the batteries are worn out. (Replace the batteries.)
If the batteries are new but the functions still fail to work, remove the batteries, unplug the lines and reinstall
the telephone after 10 minutes.
NOTE: Due to continuous product development, all features and specifications are subject to change without
prior notice

Technical Specifications:

. Telephone connection: Appliance designed for connection to an analogue telephone line class TRT3
(telecommunications network voltage) as defined by standard NF EN 60950
. Caution, the network voltage is classified as a hazard according to the criteria of this standard.
. Operating temperature: from 5º to 40º.
8