Air Filter - Daikin Siesta ATXN25LV1B Manual De Instalación

1. Open the front panel.
• Hold the panel at the recesses on the main unit
(2 recesses on right and left sides) and lift it until it
stops.
2. Pull out the air filters.
• Push a little upwards the tab at the center of each air
filter, then pull it down.
3. Take off the Bio filter with bacteriostatic,
virustatic functions.
• Hold the recessed parts of the frame and unhook the
four claws.
Titanium Apatite Filter (Bio Filter)
Attached Concept

AIR FILTER

Recess on
main unit
Air Filter
Heat exchanger
Titanium Apatite Filter
Bio Filter attached part
1-16
4. Clean or replace each filter.
See figure.
• When shaking off remaining water, do not wring the
Filter.
Filter frame
Tab
5. Set the air filter and Bio Filter with bacteriostatic,
virustatic functions as they were and close the
front panel.
• Insert claws of the filters into slots of the front panel.
Close the front panel slowly and push the panel at the
3 points. (1 on each side and 1 in the middle.)
• The air filter and Bio Filter with bacteriostatic,
virustatic functions have a symmetrical form in the
horizontal direction.
FRONT
Air filter
Bio filter with
bacteriostatic,
virustatic functions