Operating Instructions "Pneumatic Hammer; Symbols And Abbreviations; Safety Rules; General Safety Instructions For Power Tools - BizLine MP 800 Instrucciones De Manejo

Operating instructions "Pneumatic hammer"

14 English

1. Symbols and abbreviations

The symbols used in these instructions and, if ap-
GB
plicable, on the power tool serve to bring your at-
tention to potential dangers when working with
this power tool. You must understand the signifi-
cance of these symbols/notes and comply with
them in order to make its use more efficient and
safer.
The safety warnings, notes and symbols are not a
substitute for regulation measures for accident
prevention.
Symbols
Action for working with the device,
start with light pressure and increase
the pressure slowly until the desired
operation is achieved.
Follow the instructions in numerical
order.
OFF / Standstill
ON / Working position
Maintenance and installation instruc-
tions - Rotary motion
Tasks or actions which require a lock.
Recommended by the manufacturer
Further information see Page 26
Illustrated or described accessories
are not necessarily included in the
scope of delivery
Technical modifications reserved
Especially important note for safety.
Always follow this note, otherwise it
could result in severe injury.
Warning of dangerous electrical volt-
age
BH-BIZ-EN / 0709
Symbols and abbreviations
Warning of hot surfaces
-WARNING-
For a potentially dangerous situation which could
lead to physical injury or material damage.
NOTE:
Modification notes and other useful information.

2. Safety rules

General safety instructions for power
tools
WARNING! Read all instructions.
Failure to follow all instructions listed
below may result in electric shock,
fire and/ or serious injury.
SAVE THESE INSTRUCTIONS.
The term "power tool" in all the warnings listed be-
low refers to your mains operated (corded) power
tool or battery operated (cordless) power tool.
Work area
Keep the work area clean and well lit.
Cluttered and dark areas lead to accidents.
Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable liq-
uids, gases or dust.
Power tools create sparks which may ignite dust
or fumes.
Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.

Electrical safety

Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapt-
er plugs with grounded power tools.
Unmodified plugs and matching outlets will reduce
risk of electric shock.