Device Description; Specified Conditions Of Use; Requirements For The User; Technical Data - BizLine MP 800 Instrucciones De Manejo

Device description

Never use the machine with a dam-
aged cable. Do not touch the dam-
aged cable and pull the mains plug
when the cable gets damaged during
operation.
Damaged cables increase the risk of
electric shock.
Residual risk. Although this information sheet and
the operating manuals for our electrical tools con-
tain extensive instructions on safe working with
electrical tools, every electrical tool involves cer-
tain residual risks that cannot be completely pre-
vented through safety mechanisms. Therefore,
electrical tools must always be operated with the
necessary caution.
3. Device description
Read all the warnings and instruc-
tions before using the equipment.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
For help, please use the enclosed illustrations
showing the device. Open these illustrations while
reading the operating instructions.
Operating elements
I Unlocking sleeve
II Operating mode switch
III Gear selector/Rotation stop switch
IV Adjuster for speed selection (optional)
V On/Off control switch
VI Stop button
VII Left/Right rotation switch
VIII Interlock button mains cable module
IX Unlocking sleeve drill chuck (optional)
Device components
1 Tool holder
2 Dust protection cap
3 Additional handle
4 Depth stop
5 Mains cable module / fixed supply
6 Screwing adaptor
7 Quick-action drill chuck
8 Mounting spindle (optional)
Scope of supply
See packaging

Specified Conditions of Use

The pneumatic hammer drill is intended for univer-
sal use for hammer drilling in concrete, brick and
stone and for light chisel work (Exception: chisel
work with 550 PH not possible).
It is also suitable for drilling without impact in
wood, metal, ceramic and plastic.

Requirements for the user

The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.

Technical data

Mains voltage in V / Frequency in Hz
Nominal power rating P in Watts
Noise levels
L = A-rated noise level
pA
L = A-rated noise output level
wA
K = Measurement uncertainty
value
The noise level can exceed 85 dB(A)
during operation.
Wear hearing protection!
Triaxial
determined in accordance with EN
60745.
K = Measurement uncertainty value
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
English 17
vibration emission
BH-BIZ-EN / 0709
GB
level