Putting Into Operation; Additional Handle - BizLine MP 800 Instrucciones De Manejo

18 English
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
GB
over the total working period.
1st n
2nd n
1st n
2nd n
in rpm
Individual impact strength in Joule
Number of impacts n
Corner dimension in mm
Clamping location diameter in mm
Weight in kg
Your device is fitted with an SDS-plus
automatic locking device.
Your device has a manual SDS-plus
locking device.
Drilling and hammer drilling in con-
crete - max. ø in mm
Drilling and hammer drilling in brick -
max. ø in mm
Drilling and hammer drilling in sand-
stone - max. ø in mm
Drilling in steel - max. ø in mm
Drilling in aluminium - max. ø in mm
Fitting screws in wood - max. ø in
mm
Drilling in wood - max. ø in mm
BH-BIZ-EN / 0709
= Idle speed (1st gear)
0
=Idle speed (2nd gear)
0
= Load speed (1st gear)
1
=Load speed (2nd gear)
1
-1
Your electrical tool is double-insu-
lated in accordance with EN 60745;
For this reason an earth wire is not
required.
The device is suppressed against radio and TV
broadcasts, in accordance with EN 55014-1 and is
immune to disturbances in accordance with EN
55014-2.
4. Operation
Before carrying out any work on the
machine, pull the main plug.

Putting into operation

Observe correct main voltage!
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.
Fit the additional handle
Connect mains cable module if necessary
If using an extension cable: Only use
extension
approved for the application with the
required cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged cables.

Additional handle

Operate the machine only with the ad-
ditional handle
Loss of control can cause personal in-
jury.
Place the additional handle 3 in the working posi-
tion to provide a safe and fatigue-free working sit-
uation.
Tighten the lower hand grip of the additional han-
dle 3 by turning in a clockwise direction. Turn the
hand grip in an anticlockwise direction to release
it.
Operation
cables specifically