Kohler K-2238 Manual Del Usurio página 6

Install the Pedestal and Lavatory (cont.)
Install the hanger bolts to the wood backing. The hanger bolts
must extend 1-1/4" (3.2 cm) beyond the finished wall.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
CAUTION: Risk of product damage. Do not overtighten the
wood screw. Overtightening may damage the product.
Move the pedestal over the drilled hole in the floor. Secure the
pedestal to the floor by carefully tightening the wood screw and
washer.
Carefully set the lavatory on the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Install the cap nuts and washers to the hanger bolts. Level the
lavatory, then carefully tighten the cap nuts until snug.
Connect and tighten the trap to the drain.
Complete the water supply connections to the faucet according to
the instructions packed with the faucet.
1020735-2-C 6 Kohler Co.