Preventative Maintenance; Daily Maintenance; Weekly Maintenance - Indoor Cycling LIVESTRONG E-Serie Manual De Instrucciones

PREVENTATIVE MAINTENANCE

Regular maintenance must be performed on the LIVESTRONG E-Series for optimal
performance and longevity. Please read and follow all instructions below. If
the LIVESTRONG E-Series is not maintained as described, components may
wear excessively and the LIVESTRONG E-Series may become damaged. Im-
proper maintenance will void the warranty terms. If you have questions about
maintenance, contact your local distributor or refer to www.indoorcycling.com
Note: Many maintenance procedures require lubricant spray. Manufacturer
recommends WD40, Brunox or a similar solvent free lubricant.

Daily maintenance:

1. Make sure that the LIVESTRONG E-Series is level. If the LIVESTRONG E-Series rocks
on your floor, turn the levelling feet underneath the front or rear stabilizer until the rocking
motion is eliminated (see HOW TO MOVE THE LIVESTRONG E-Series on page 23).
2. After each user finishes exercising, the LIVESTRONG E-Series should be disinfected
and cleaned to maintain a hygienic environment. First, apply a disinfectant spray to the
handlebars and the saddle. Using a lint-free cloth, dry the handlebars and the saddle. Next,
apply a small amount of disinfectant to a lint-free cloth and clean the adjustment knobs
and the adjustment handles. Avoid using strong detergents on the LIVESTRONG E-Series
frame.

Weekly maintenance:

1. Apply a small amount of the lubrication spray to a lint-free cloth, and thoroughly clean
the frame, the handlebar slider and seat sliders the flywheel and the plastic parts of the
LIVESTRONG E-Series.
2. For optimal performance of the resistance
2
system, and to minimize wear on the brake pad,
the solvent free lubricant spray should be applied
to the brake pad using the lubrication holes on the
plastic part of the brake pad. If fuzz or lint appears
on the brake pad, the brake pad has become too
dry—lubricant spray should be applied more
frequently. Make sure brake pad is thoroughly
soaked from end to end with lubricant spray.
Then, wipe the excess off.
Version 1.2 2010 EBLS Copyright by Indoorcycling Group GmbH 2010 | www.indoorcycling.com ENG 24