Yakima LOADRANGER 16S Manual De Instrucciones página 2

MEASURE THE DISTANCE BETWEEN THE CROSSBARS ON YOUR RACKS.
FOR BARS THAT CAN'T MOVE:
(INCLUDING Q TOWERS)
Measure from bar to
bar to determine
which sets of holes
your box will use.
ADDITIONAL HOLES.
ON THE OUTSIDE OF THE BOX:
• CARRIAGE BOLT:
Insert through curved bracket,
then through large plate.
• T-BOLT:
1032957D-2/12
DO NOT LOAD THE BOX ONTO THE CAR YET.
Q TOWER NOTE:
NEVER REPOSITION
THE TOWERS!
DO NOT DRILL
Insert through
large plate only.
Curved bracket
should swing freely.
FOR BARS
THAT MOVE OR SLIDE:
Bars should be
positioned at 30"
to 36" apart .
0" 0"
INSIDE OF BOX: ATTACH KNOBS:
Set metallic plate
onto bolts. Engage the threads of the bolts
with one slight turn—no more.
The knobs must be very loose.
TIGHTEN YOUR
CROSSBARS IF YOU
LOOSENED THEM.
30"– 36" 33"– 36"
INSIDE THE BOX:
Push plugs into
unused holes.
Attach adhesive pads
to metallic plates.
LOAD BOX ONTO
RACKS.
Curved brackets should
swing freely.
Be sure the brackets are
not interfering when box
is positioned on the bars.
A friend could help
with this part.