Check Installation - Yakima LOADRANGER 16S Manual De Instrucciones

SECURE THE BOX TO THE BARS:
Swing brackets into position under bars.
Attach brackets to T-bolts.
TO CLOSE YOUR BOX:
Grab the lid strap
and pull down until
you can reach it
with your hands
.
Place the strap
inside the box.
PERFORM SAFETY CHECKS:
CHECK ALL 3 LATCHES
Push up on the lid at each latch.
CAUTION: Overstuffing the box
will prevent a secure closure.
1032957D-3/12
LOCK T-BOLTS:
T-bolt is locked when "T" is
parallel to the crossbars.
CLOSE LID COMPLETELY:
ALL THREE
LATCHES must
produce an
audible
"click"
before the
box lid is
secure.

CHECK INSTALLATION:

Make sure installation is secure by
tugging at box.
The box should NOT SLIDE on the bars.
Open the box and tighten knobs if
necessary.
TIGHTEN THE KNOBS.
Tighten the knobs until the box
cannot slide on the bars.
DO NOT OVERTIGHTEN!
TO LOCK:
• Insert key
• Push knob
in and turn
key
TO OPEN THE BOX:
• UNLOCK. Handle will pop out.
REMEMBER...
NEVER REPOSITION YOUR
YAKIMA Q TOWERS!
Caution:
When installing or
removing SKS
cores, handle must
be in unlocked
position. Do not
press handle while
installing or
removing cores.
• TURN KNOB CLOCKWISE.
Gently raise lid.