Important; Installation And Set-Up; Gefahren; Weitere Gefahren - Modine ECO TKE Manual Tecnico

Important

1. This manual is an integral part of the product and as
such must be kept for the entire lifespan of the unit.
2. Carefully read the instructions before installation and pri-
or to any intervention on the model, in case of doubt con-
tact the manufacturer.
3. The model described in this manual cannot be used as
supplied as it is a component for refrigeration systems and
must be installed by qualified personnel only (see also In-
stallation and Set-up).
4. Do not alter or tamper with the components of the model.
5. Installation must be carried out in accordance to the rel-
evant local laws and to specific conditions of project.
6. The manufacturer shall not be held liable for inconve-
niences, breakdown or accidents owing to disrespect of
the indications of this publication.
7. This manual reflects the state of technology at the mo-
ment of marketing the product, therefore it cannot be
considered incomplete should the evolution of the meth-
ods of design and manufacture require an update of the
data stated herein.
Applications
1. Product description: air cooled condenser with axial fan
motors suitable to condense refrigerants in steam com-
pression installations.
2. The model must be used exclusively for the purpose for
which it has been designed: misuse or improper use ex-
empts the manufacturer from any responsibility.
Use in non-specified and irregular conditions shall be
considered incorrect, i.e. improper.
3. The minimum protection grade for this model is IP54.
Consult the enclosed "PED DATA SHEET" or "ADDI-
TIONAL INFORMATION SHEET" (when included).
Identification
For information or requests for assistance, supply the name and
the serial number printed on the model name-plate.
Instructions for a correct location
Minimum distance from walls
0,4 m
Inspection, transportation, handling
1. Upon receipt the unit should be immediately visually in-
spected and the shipping forwarder notified of any da-
mages or shortages. The packaging has been designed
to suit model, adequate means of transport and hand-
ling.
2. During transport of model it is necessary to avoid ap-
plying inappropriate pressure on the package, and it mu-
st be kept in the position specified.
3. The model packaged model must be moved and positio-
ned by qualified personnel by means of one or more ade-
quate fork-lift trolleys (see dimensional features). In order
to prevent possible falls the forks must be longer that the
depth of the package. Avoid abrupt movements and keep
away from maneuvering area.
Always secure models to lifting equipment before starting
relocation operations; possible collisions or violent shoves
may knock over model.
4. The model must be stored in its original crate in a shel-
tered location.
5. Do not stack other material on packaged model.

Installation and set-up

1. The installation and set-up of the unit must be carried
out by qualified personnel.
2. The model is equipped with axial type fan motors that are
not suitable to sustain additional static pressures, the-
refore it cannot be fitted with duct ventilation systems or
with filters at the air suction side, and should not be in-
stalled in areas with strong air currents that clash with the
air flow of the fan motors.
3. The model must be installed preferably outdoors, should
it be situated in a closed area it is necessary to predispose
an air vent in order to totally exclude additional static
pressure.
4. Ensure that the structural support and the relevant fixing
points can carry the weight and accommodate shape of
the unit (see table with technical features).
5. The model is not designed to be used as a support for
other components.
CAUTION
Before carrying out maintenance on unit, make sure
that the electrical feed is disconnected from main
power source: the electric parts may be connected to
an automatic control system.
2 m
17
www modine com