Installation Of Safety Support - Hinkley 52 AFTON Manual De Instrucciones

1
Slip the yoke cover, trim ring and canopy onto the downrod.
(Fig. 3)
Slide the hanger ball onto the downrod, insert the cross pin
2
through the downrod and tighten. Tighten the set screw.
Fan has 6 feet of hook-up wire in case you are using
a long extension downrod.
Lift ball/downrod/fan into hanger bracket opening.
3
NOTE: The tab opposite hanger bracket opening should fit
in slot on ball. (Fig. 4)
Make wire connections, (refer to section titled "Electrical
4
Connections").
Slide canopy up and fasten to hanger bracket with 4 screws
5
provided.

INSTALLATION OF SAFETY SUPPORT:

Attach the lag bolt and flat washer to ceiling joist.
Attach the safety cable to lag bolt. Slide cable
clamp onto safety cable (from fan). Place the
end of cable through the lag bolt. Pull as much
cable through lag bolt as possible. Feed end of
cable into clamp hole and firmly tighten screw
(Fig. 4). Cut off excess safety cable.
NOTE:
Cross pin
Hanger ball
Hook-up (3) Wires
Downrod
Yoke cover
Top of
Fan Body
Fig. 3
Hanger bracket
Safety cable
Fig. 4
©2020 Hinkley Lighting, Inc. | hinkley.com |
Ground Wire
Set screw
Safety Cable
Canopy
Trim Ring
Safety cable clamp
07