Installation Of Removable Switch Housing - Hinkley 52 WINDWARD Manual De Instrucciones

INSTALLATION OF REMOVABLE SWITCH HOUSING

WARNING: Be sure electricity is turned off at the main power box before wiring.
1 Loosen the 3 side screws on switch housing hub halfway.
If installing light kit, carefully remove light kit plug in bottom of switch housing. Attach light kit to switch housing per instructions
2
supplied with light kit. See "Electrical Connections" for hook-up of light kit.
3
Connect the plug and receptacle and make sure side buckle snaps in place.
Attach the switch housing to the switch housing hub. Be sure to align the opening on the edge of switch housing hub with reverse
4
switch.
5
Align the side screws with keyhole slots on edge of switch housing and tighten the side screws.
6
Attach pull chain fob to end of the switch's pull chain.
7
Turn the power on. Your Ceiling Fan is now ready to enjoy!
12 | hinkle y.com
Switch Housing Hub
(bottom of motor)
Connector (receptacle)
Keyhole Slot (x3)
Optional Light Kit
Screws Into Bottom
of Switch Housing
Side Screw (x3)
Connector (plug)
with Side Buckle
Switch Housing
Pull Chain
Reverse Switch