Installation Of Removable Switch Housing - Hinkley TROPIC AIR 52 Manual Del Propietário

INSTALLATION OF REMOVABLE SWITCH HOUSING

Mounting plate
Fig. 1
1
Remove the 1 of 3 screws from the mounting hub and keep it
for future use. Loosen the other 2 screws. (Do not remove)
Place the key holes on the mounting plate over the 2 screws
2
previously loosened from the mounting hub , turn mounting
plate until it locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws previously loosened
and the one previously removed. (Figure 1)
Mounting Hub
(bottom of motor)
Screws
Wire connectors
DetachableSwitch
housing
Fig. 2
Remove the 1 of 3 screws from the mounting plate and loosen
1
the other 2 screws. (Do not remove)
Raise and hold the DetachableSwitch housing close to the
2
mounting plate and push the square wire connectors together.
(Fig. 2)
Place the key holes on the DetachableSwitch housing over the
3
2 screws previously loosened from the mounting plate, turn light
kit until it locks in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously loosened and the
one previously removed. (Fig. 2)
Mounting plate
©2019 Hinkley Lighting, Inc. | hinkley.com | 11