Intended Use; Possible Misuse; Items Supplied - Hilti DSH 600-X Manual De Instrucciones Original

3.2

Intended use

The product described is a gasoline-powered cut-off saw for the wet or dry cutting of asphalt, mineral
construction materials or metals using diamond cut-off wheels or abrasive cut-off wheels.
The saw is not suitable for use in environments where there is risk of fire or explosion.
3.3

Possible misuse

▶ "Shoveling" with the gasoline-powered saw is not permissible.
3.4 Instructions for use
• Use of the wet cutting method is preferable in order to reduce the amount of dust produced when cutting.
By using the self-priming water pump (accessory) you can work without need for a water supply hose.
The water can be drawn, for example, directly from a container.
• Do not cut right through the workpiece in one pass. Move the saw back and forward several times until
it gradually reaches the desired cutting depth.
• To avoid damaging the diamond cut-off wheel when dry cutting, lift the wheel out of the cut for approx.
10 seconds every 30 to 60 seconds while the saw is still running.
• Resharpen a polished diamond wheel (i.e. when no diamonds project from the segment matrix) by cutting
with the wheel in a very abrasive material such as sandstone.
3.5 Cut-off wheel specifications
WARNING
Risk of injury. The use of cut-off wheels that are not in compliance with the ANSI standard can increase the
risk of injury for the user.
▶ Do not use cut-off wheels that are not in compliance with the existing ANSI standard for cut-off wheels.
Diamond cut-off wheels in accordance with ANSI B7.1 are to be used with the product. Synthetic resin-
bonded, fiber-reinforced cut-off wheels in accordance with ANSI B7.1 (flat, not depressed-center, type
cut-off wheel) may also be used with the product for working on metals.
The instructions for use and installation instructions issued by the cut-off wheel manufacturer must be
observed.
3.6

Items supplied

DSH 600-X gasoline-powered saw, tools set, DSH 600-X wear parts and consumables set, operating
instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.7 Consumables and wearing parts
• Air filter
• Cord
• Starter
• Fuel filter
• Spark plug
• Tool set
• Cylinder set
• Mounting screw assy.
• Flange for abrasive cut-off wheel (with integral centering ring 20 mm/1")
• Flange for diamond cut-off wheel (with integrated centering ring 20 mm/1")
8 English 2136487
*2136487*