Hilti DSH 600-X Manual De Instrucciones Original página 29

warrants to the initial purchaser and each subsequent purchaser that the emission-related warranted parts
are free from defects in material and workmanship which cause the engine to fail to conform with applicable
regulations for a period of two years. These warranty periods will begin on the date small non-road equipment
engine is purchased by the initial purchaser. If any emission-related part on your engine is defective during
this warranty period, the part will be replaced by Hilti at no cost to the owner. Hilti shall remedy warranty
defects at authorized Hilti service and repair centers. Any authorized work done at an authorized Hilti service
and repair center shall be free of charge to the owner if it is determined that a warranted part is defective.
Any manufacturer-approved or equivalent replacement part may be used for any warranty maintenance or
repairs on emission-related parts, and must be provided free of charge to the owner if the part is still under
warranty. Hilti is liable for damages to other engine components caused by the failure of a warranted part
still under warranty. The California Air Resources Board's Emission Warranty Part List specifically defines
the emission related, warranted parts. These warranted parts are: the carburetor assembly, coil assembly,
rotor, spark plug, air filter, fuel filter, breather manifold and the gaskets.
Maintenance requirements
The owner is responsible for performing the required maintenance as defined by Hilti in the owner's manual.
Limitations
The Emission Control Systems Warranty shall not cover any of the following: a) repair or replacement
required because of misuse, neglect or lack of required maintenance, b) repairs improperly performed or
replacements not conforming to Hilti specifications that adversely affect performance and/or durability, and
alterations or modifications not recommended or approved in writing by Hilti, and c) replacement of parts
and other services and adjustments necessary for required maintenance at and after this first scheduled
replacement point. Except as set forth above, the warranty terms set forth in section 12 below, apply.
11.2 Manufacturer's warranty
Hilti warrants that it will repair or replace any part containing a defect in material and workmanship for 20
years from the original sale date. This warranty is valid so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with the Hilti Operating Instructions, and the technical
system is maintained. This means that only original Hilti consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or replacement of defective parts only over the entire lifespan
of the tool. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this
warranty.
Additional claims are excluded, unless stringent national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inability to use the tool for any purpose. Implied
warranties of merchantability or fitness for a particular purpose are specifically excluded.
For repair or replacement, contact Hilti immediately upon discovery of the defect at:
In the USA:
800.879.8000
Hilti Inc.
7250 Dallas Parkway, Suite 1000
Plano, TX 75024
CS.InboundUS@hilti.com
In Canada:
800.343.4458
Hilti (Canada) Corporation
2360 Meadowpine Blvd
Mississauga, ON L5N 6S2
CanadaSalesSupport.English@hilti.com
CanadaSalesSupport.French@hilti.com
This constitutes Hilti's entire obligation with regard to warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning warranties.
2136487 English 21
*2136487*