Cleaning And Maintenance; Simple Troubleshooting - Pur Line MISTY 2 Manual Del Usuario

CLEANING AND MAINTENANCE

· Unplug the unit before cleaning.
·Any greasy dirt on the fan and fan blade should be cleaned with clean and mild detergent and soft
cloth.
· First, disassemble the fan (diagram 2).
· Clean the greasy dirt on the fan so as not to change the colour or cause damages:
- Clean with detergent and soft cloth.
- Avoid flushing with water directly.
- Avoid cleaning with thinner, toluene, acids, kerosene, essential oils, chemistry cloth so as not to
change the colour or cause damages.
· After cleaning, pack them in order and keep it in the dry place.
·
Cleaning of water tank (once a week)
If there is dirt in the water tank, clean it with detergent and flush it with clean water.
Notes
:
1) Do not touch the transducer with sharp tools, only clean with soft wet cloth.
2) Don't use the cloth with chemical solvents gasoline kerosene polishing powder to wipe the fan
appearance.
3) Avoid the water going into the appliance, it can cause malfunction.
4) Keep the appliance clean.
When the unit is not used for a long time, clean it and put it in the packaging and keep it in the dry place.

SIMPLE TROUBLESHOOTING

If your fan is not working properly, please check the following table before sending it to a service agent:
Problems
The fan doesn't work when it's
started.
The fan doesn't swing
but has wind.
Humidifier indicator light not
working. No wind, No mist
Himidifier indicator light
illuminate
Having wind
No mist
The mist is smelly
Humidifier indicator light
illuminate
No wind, No mist
EN
Possible Reasons
1. The power cord plug is not
connected properly and electric
power is off.
2. The switch is off.
SWING button is off
1. Plug not inserted properly
2. Power switch is turned off
1. No water in the water tank
2. Auto temperature knob isn't
open
3. Tank cover is not well placed
1. New product
2. Whether the water tank
or water is cleaned
Too much water in the tank
9
Solution (s)
1.Whether the plug is inserted into the
socket or connected well.
2. Wheteher switch is "ON"
Whether the Oscillate switch is "ON"
1. Insert the plug properly
2. Switch power "ON"
1. Fill the tank with water
2. Open auto temperature knob by
clockwise
3. Press float cover well
1. Open the water tank for 12 hours in
the cool place
2. Clean the water tank and change
the water
Decrease some water and tighten the
cover