Tristar SZ-1915 Manual Del Usario página 14

Parts list
1. Suction Hole
2. Holes for attaching the Schoulder strab
3. On/off switch
4. Handle
5. Push to open dust clip (container
6. Dust cup (container)
7. Dust cup filter
8. Cleaning brush
9. Crevice brush
10. Plug
11. Flexible Hose
12. Shoulder strab
ASSEMBLY
Warning. Always unplug from electricaI outlet before opening the dust cup (contairer) (6). Note: Dust cup filter (7)
must be used when operating the hand vacuum cleaner
USING THE UNIT AS A HAND VACUUM
1- To open the dust cup (container) (6), push button (5) an pull out the dust cup (6). Verify that the dust cup filter (7)
is inside, then attach the dustcup (container 10) to the hand vacuum.
2. To use the hand \Iacuum with the shoulder strap (12), attach it to the unit
3- To attach the cleaning brush (6) or crevice brush (9) to the Hand Vacuum. push brush into the suction hole (1). as
shown below.
4. To use the flexible hose (11), push the end of the hose into the suction hole (3), then attach the desired brush
(6. or 7) to the other end of the flexible hose (11), as shown below.
HOW TO OPERATE YOUR HANID VACUUM
1. Hold the hand vacuum firmly with your hand on the Handle (4).
2. Push the On/Off Power Switch (3) to "On'* position.
3. Start vacuuming.
CAUTI ON: -The Hand Vacuum is a very powerful unit. Make sure that you hold it firmly. Otherwise it can slip out of
you r hand and cause injury
CHANGING & CLEANING THE DUST CUP FILTER
Warning: Always unplug from the electrical outlet before opening the dust Cup (container) (6).
1. To open the Dust Cup (container (6), push button (5) and pull out The Dust cup (container) (6).
2. Pull out the Dust Cup Filter (7).
3. Empty the dust from the Dust Cup Filter (7)
4. Rinse the Dust Cup Filter (7) in cold water, and then wait until it dries compIetely before replacing it into the dust
cup (container) (6).
5- Place the Dust Cup Filter(7) carefully into the Dust Cup (container) (6).
6- Attach the Dust Cup (container) (6) to the Hand Vacuum,