Scope of supply
1x ignition cover protection holder
1x aluminum protector
2x countersunk screw M5x10
1x collar screw M6x50
3x collar screw M6x45
3x spacer, short
1x spacer, long
This product has not been homologated and therefore does
not have offi cial approval for use on public highways. The
customer must check with the national regulatory authorities to
establish whether individual type approval or a full homologa-
tion of the particular vehicle with the ignition cover protection
installed is guaranteed in the planned country of use.
Preliminary work
- Remove the front spoiler (see the user manual).
Preassembly
- Position protector
on holder
(all included).
- Mount and tighten screws
(included).
- Position long spacer
.
- Position short spacers
.
Assembly
- Lay vehicle on its side.
- Remove screws
.
- Release the remaining screws of the ignition cover.
Place a suitable container under the engine. Engine oil may
escape!
5