KTM Power Parts 93512966044 Manual Del Usuario página 6

- Position preassembled ignition cover protection.
- Mount screw (included), but do not tighten yet.
- Mount screws (included) but do not tighten them yet.
- Tighten all screws on the ignition cover in a crisscross pattern to 12 Nm.
Final steps
- Install the front spoiler (see the user manual).
NOTE
If the distance between the holder and the front spoiler is smaller
than 3 mm, we recommend adapting the front spoiler with appropri-
ate workshop equipment.
- Check engine oil level, add if necessary.
6