Kohler K-3199 Guia De Instalacion página 5

Clamp
Hex Nut
Clamp Mounting
Clip
"J" Channel Sealant
2. Install the Sink
CAUTION: Risk of personal injury or product damage. Large
sinks are very heavy. Get help lifting the sink into place.
Carefully cut along the inside line to cut out the opening in the
countertop.
Carefully place the sink upside down and attach the mounting
clip onto the "J" channel.
Hand tighten the screw until the mounting clip fully engages the
"J" channel.
Space the rest of the fasteners equally around the sink. Rotate the
clamps so they are parallel to the sink edge and tighten the nuts.
Install the faucet and strainer according to the manufacturer's
instructions.
Apply a bead of quality sealant to the underside of the sink rim.
Set the sink into the cut-out and position squarely.
Starting with the fasteners located in the middle of each side,
loosen the nuts and rotate the clamps over the countertop.
Tighten the hex nuts from under the sink until a watertight seal is
obtained. Do not tighten using the screw.
Rotate the remaining clamps and tighten the hex nuts until the
entire rim is sealed. Do not overtighten. It is only necessary to
draw the rim down firmly to the countertop.
NOTE: The fasteners may need to be repositioned to compensate for
an uneven countertop.
Kohler Co.
Silicone
Hex Nut
Sealant
Cap
Sink
Mounting
Screw
Clip
Cap
Clamp
5
Countertop
Hex Nut
Screw
1019942-2-A