Yamato ER 1200K Manual Del Usuario página 15

ER 1200K – cod. 52629
5. OPERATING INSTRUCTIONS
ATTENTION ! : This router can work wood and plastic materials, DON'T use with metals or stone.
5.a Fitting the cutter
✓ Using the spanner (14), loose the clamping nut (9)
✓ Extract the collet (B) and check if the size is correct for
the cutter which is to be using (eventually substitute it)
✓ Loosely screw the clumping nut and insert the cutter (C)
in the collet
✓ Insert the shaft stop pin (12)to hold the spindle, then tight
the clumping nut using the spanner
✓ REMOVE THE SHAFT STOP PIN before continue !
5.b Fitting the dust collector
✓ Using the two countersunk head screws, fasten the dust collector to
the routing base
✓ The dust collector can be connected to dust extractors with suction
hose with diameter 36 mm. For other size use adapter.
5.d Adjust depth of cut
✓ Place the machine on the workpiece
✓ Loose the setting screw (2)
✓ Lower the machine slowly until when the cutter touch the
workpiece
✓ Set the dept stop(6) together with the stopper for a fine setting,
then fix the setting screw (2) to fix the desired position.
✓ Switch on the machine and lower the router to perform the routing
job
ATTENTION ! :
✓ The routing job have to be done in the opposite way of the cutter
rotation to avoid risk of back kick.
✓ Deeper cuts have to be performed in several passes.
✓ Hold the router always with both hands on all cutting jobs.
5.e Switch on and off
✓ Press the switch. To switch off, release the switch.
6 ACCESSORIES AND USE
6.a. Fitting the parallel stop
✓ Insert the parallel shaft of the parallel stop in the holes
of the routing base
✓ Connect the scale on the parallel shaft
✓ Adjust the parallel stop to the required distance and fix
it with the setting screws (6)
6.b Fitting the trammel point
✓ Remove the parallel stop to use one of the 2 poles
✓ Fasten the trammel point to the parallel pole
✓ Place the trammel point on the workpiece
15