MADER KM0408312 Manual Del Usuario página 59

machine which may be malfunctioning.
In start‐up or during operation of the engine, never touch hot parts such as the
muffler, the high voltage wire or the spark plug.
After the engine has stopped, the muffler is still hot. Never place the machine in any
places where there are flammable materials (dry grass.etc.) combustible gasses or
combustible liquids.
Pay special attention to operation in the rain or just after the rain as the ground may
be slippery.
If you slip or fall to the ground or into a hole, release the throttle lever immediately.
Be careful not to drop the machine or hit it against obstacles.
Before proceeding to adjust or repair the machine, be sure to stop the engine and
detach the spark plug cap from the spark plug.
When the machine is placed in storage for a long time, drain fuel from the fuel tank
and carburetor, clean the parts, move the machine to a safe place and confirm that
the engine is cooled down.
Make periodic inspections to assure safe and efficient operation. For a thorough
inspection of your machine, please contact a dealer.
Keep the machine away from fire or sparks.
It is believed that a condition called Raynaud's phenomenon, which affects the fingers
of certain individuals, may be brought about by exposure to vibration and cold.
Exposure to vibration and cold may cause tingling and burning sensations followed by
loss of color and numbness in the fingers. The following precautions are strongly
recommended because the minimum exposure which might trigger the ailment is
unknown.
Keep your body warm, especially the head, neck, feet, ankles, hands and wrists.
Maintain good blood circulation by performing vigorous arm exercises during frequent
work breaks and also by not smoking.
Limit the hours of operation. Try to fill each day with jobs where operating the brush
cutter or other hand‐held power equipment is not required.
If you experience discomfort, redness and swelling of the fingers followed by whitening
and loss of feeling, consult your physician before further exposing yourself to cold and
vibration.
Always wear ear protection, loud noise for long time can make hearing debase even
lost hearing.
Total face and head protection must be wear to prevent damage from plummet or branch.
Wear no‐slip heavy duty work gloves to improve you grip on the brush cutter handle.
Gloves also reduce the transmission of machine vibration to your hands.
WARNING: The cutter area is still dangerous while the machine is coasting to a stop.
Note: Noise and vibration
1.The running at low speed can reduce the noise and quiver.
2.In order to reduce noise, the brush cutter should be operated at an open environment.
3.The vibration can be lowered if the handle is grasped firmly.