MADER KM0408312 Manual Del Usuario página 67

CUTTING WITH A BLADE
The black guard which contains a cut‐off knife
must be take down.
There are many different types of blades,
however the two most commonly used are the
following.
BRUSHBLADE is used for cutting brush and
weeds up to 3/4" in diameter.
SAW BLADE is used for cutting growth from 3/4"
to 3" in diameter.
WARNING
Use the shoulder harness at all times.
Adjust both harness and harness clamp
on the unit so that the unit hangs a few
inches above ground level. The cutting
head and the metal debris shield should
be level in all directions. Harness the
unit on the right side of your body.
CUTTING WITH BLADE
CAUTION
WARNING
DO NOT TOUCH THESE TYPES OF OBJECTS
WITH BLADE
METAL STAKES
UTILITY WIRES
ROCKS MASONRY
WARNING
DO NOT USE A BRUSH CUTTER FOR
CUTTING TREES.
WARNING
Do not cut with dull, cracked or
damaged metal blade.
Before cutting growth, inspect for
obstructions such as boulders, metal
stakes or strands of wire from broken
fences. If an obstruction cannot be
removed, mark its location so that you
can avoid it with the blade. Rocks and
metal will dull or damage a blade. Wires
can catch on the blade head and flap
around or be thrown into the air.
CAUTION
RUBBER
FENCES
CAUTION
CAUTION