MADER KM0408312 Manual Del Usuario página 72

Clean or replace the plug if fouled with heavy oily deposits.
Replace the plug if the center electrode is worn rounded at the end.
Spark gap 0.6‐0.7mm(.023",.028")
Fastening torque=145‐155kg.com(125‐135in.lb)
TRANSPORT, HANDLING
Blade guard should be installed when
transport, handing of the unit.
INSTALLING BLADE GUARD
Cleft the blade guard and install on the
blade, then put the pin into the guard
notch.
The engine should be turned off when
the unit is moved between work
areas.
After the engine has stopped, the
muffler is still hot. never touch hot
Parts such as the muffler.
Confirm that the fuel is not leaked
from tank.
EXTENDED STORAGE
Inspect, clean and repair unit if
necessary.
Remove engine‐This will consume all
fuel in fuel line and carburetor.
Remove spark plug and pour on tea
Spoon of clean motor oil into spark
plug hole of cylinder‐replace spark
plug.
Store in clean, dry dust free area.
FAILURES such as difficulty in starting
engine, irregularity in functions and
abnormality in performance can normally
be prevented if careful attention is paid to
all operating instructions and
maintenance procedures.
Should the engine not function properly,
check the following:
TROUBLE SHOOTING
BLADE
INSTALLING BLADE GUARD
That the fuel system is in good condition
and fuel is flowing to the engine.
The ignition system is in good condition
and the spark plug, sparks correctly.
Compression of the engine is adequate.
FAILURE TO START
Dispose of fuel in tank.
Insure that fuel is fresh and clean.
Check fuel filter to make sure it is
clean.(replace filter if necessary).
Make sure air filter elements are
clean.
Install new, properly gapped spark
plug.
When there is serious trouble with
the unit, do not try to repair it
yourself, but have your distributor or
dealer do it for you.
BLADE GUARD