Starting Cold Engine - MADER KM0408312 Manual Del Usuario

ENGINE STARTING AND
STOPPING PROCEDURES

STARTING COLD ENGINE

1.Move the stop to "START "position.
2.Give a gentle push on the primer pump
repeatedly (7‐10 times) until fuel comes
into the primer pump.
3.Cold Starts: Pull lever up to close choke.
4.Pull starter handle until engine false
fires.
5.Push choke lever inwards (excessive
cranking with choke lever will cause
flooding engine making it difficult to
start.)
6.Pull starter handle until engine starts.
7.Allow engine to warm up for a few
minutes before using.
OPERATIONS
SAFETY LEVER
STARTING WARM ENGINE
If fuel tank was not run dry, pull starter one
to three times and engine should start.
DO NOT USE CHOKE
If fuel tank was run dry, after refilling
repeat steps 3 thru 7 in STARTING COLD
ENGINE.
STOPPING THE ENGINE
Move switch to STOP position.
STOP SWITCH
THROTTLE LEVER