Yakima Q Towers Manual De Instrucciones página 3

REAR TOWERS INSTALLATION:
Measure bar BETWEEN tower hoods—
IMPORTANT: Follow "M3" measurement
from list in clip box.
M3
Keep screws in
Towers loose.
Install REAR pads
and endcaps:
Put a rubber pad from
the clip box, on the base
of each tower.
USE COMBINATION OF M2 AND M4
FOR TOWER LOCATION.
Measure from top of windshield where paint
ends, to front of rear tower.
M4
+
M2
1033071A-3/15
Check measurement... lock towers:
• Lift Tower hood and crossbar
TOGETHER so that Tower drops.
• Insert wrench in hole.
• Turn wrench a short turn clockwise—
LABEL REAR
this locks the Tower to the Bar.
towers with
rear stickers.
Repeat with other tower.
CHECK MEASUREMENT AGAIN!Tower
may have moved during tightening.
Put black endcaps on
front bar.
FOR
EXAMPLE:
OPEN VEHICLE DOORS.
• With doors open, gently place the rack on
vehicle roof.
• Center the rack: Measure side to side.
Door frame to Tower base must be equal
on both sides of car.
Tundra Tower Location = 38"
Correct
measurements
can be found
in Q Clip box
or in Fit List
(at your dealer).
M2 = 6"
+ +
M4 = 32"