Yakima HullRaiser Manual De Instrucciones página 3

ALIGN SNAPAROUNDS TO LARGE HOLES IN BASE.
• Insert bolts through large holes in base and into SnapArounds.
• Make sure bolt is fully seated
to install hex key.
MIGHTYMOUNTS
must use kit #8860007.
See your dealer.
Use longer hex bolts
with hex wrench
from kit.
LOAD BOAT AND TIE DOWN SECURELY.
• Loop strap around hoop of
HullRaiser.
• Bring straps up and over boat so
that they hang in front of the boat.
1033087D-3/12
• Slide buckle up
so that it hangs at
top edge of boat.
• Thread end of
strap around
Tower or
Crossbar.
Attach Hex Keys
onto bolts.
TIGHTEN.
Foam pads can be
moved up or down,
or offset to support
boat at contact
points.
SECURE STRAPS.
• Press open buckle.
• Insert end of strap.
• To tighten
straps, hold
and pull.