Section 4: Maintenance And Troubleshooting; Maintenance; Maintenance Schedule - Generac GC2200T Manual Del Propietário

Section 4: Maintenance and Troubleshooting

Maintenance

Regular maintenance will improve performance and extend
engine/equipment life. Regular maintenance, replacement,
or repair of the emissions control devices and systems may
be performed by any repair shop or person of the owner's
choosing. To obtain emissions control warranty service
free of charge, contact Generac Customer Service at 1-
888-436-3722 (1-888-GENERAC),
erac.com. See the emissions warranty.

Maintenance Schedule

Procedure
Check engine oil level
Clean engine exterior, cooling fins, and remove collected grass*
Check general equipment condition
Replace broken or frayed cutting cords
Check Mow-Ball line plates for excessive wear
Replace the trimmer belt. See
more information.
Lubricate throttle cable and trimmer control cable with SAE 30 oil
Replace engine oil
Replace engine air filter cartridge and foam pre-filter if equipped
Remove trimmer guard and clean out any collected debris
Replace spark plug
* Cleaning the top of the engine during use is critical for proper air flow.
Owner's Manual for Trimmer/Mower™
or www.gen-
Replacing Trimmer Belt
Accidental Start-up. Disconnect spark plug wire
when working on unit. Failure to do so could result
in death or serious injury.
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces could
result in severe burns or fire.
Before Every 25
Each Use Hours





for
1st time 5
hours
Maintenance and Troubleshooting
WARNING
WARNING
Every 50 Every 100
Hours





(000102)
(000108)
Hours

15